Hand pumps to furnish drinking water from wells and cisterns

HAND PUMPS
for WATER WELLS

DEAN BENNETT SUPPLY
Toll Free 800 - 621 - 4291

MADE IN THE U S A

BAKER / MONITOR FULL SIZE DEEP WELL HAND PUMPS

$ 722.00		#11-HD Hand pump stand with standard open spout
$ 893.00		#12-HD Hand pump stand with bibb spout shut off
$ 956.00		#12-HDA Hand pump stand with bibb spout, with 2" tapping for tubular well
$ 1737.00		#1DFHCS Fountain hand pump stand
$ 431.00		#100DPS Hand pump shroud conversion kit
$ 1001.00		#11HDS 11 HD Hand Pump with Shroud Kit Installed
$ 1192.00		#12HDS 12 HD Hand Pump with Shroud Kit Installed
$ 91.75		#66-MP Sealed pump flange for 6" steel casing
$ 90.50		#65-MP Sealed pump flange for 5" steel casing
$ 87.25		#64-MP Sealed pump flange for 4" steel casing
$ 47.95		#146-HD Allows garden hose connection to spout
$ 60.75		#1-HPS Screen Kit for on spout of hand pumps to keep mice out.
Baker Hand Pump Repair Parts Baker's force pump stands ( deep well hand pumps ) are for use with windmills, pump jacks, or as a stand alone hand pump. They have a built in surge chamber, an adjustable stroke, and a multi-position cap. The #12-HD is identical to the #11-HD, except that it has a bibb spout in place of the standard open spout. The wheel handle valve in the bibb spout allows you to shut off flow to the spout, which allows water to be diverted thru an outlet plug on the back of the hand pump over to another point ( such as a storage cistern ).
Baker's Fountain Pump Stand is available out of the factory on a special order basis, so please allow extra time for delivery. A few strokes of the handle fills a reservoir with water which without further pumping becomes a smooth flowing drinking fountain. Factory installed #100DPS shroud assembly is standard on Fountain Pump Stands.
Sealed pump flanges allow your hand pump to be bolted directly onto your steel well casing.
Shroud kit replaces the standard pump cap and flat bar to insure added sanitary protection. It is recommended by many state and federal health / sanitary agencies.

TABLE OF HAND PUMP DATA
Cylinder	5" Stroke	7-1/2" Stroke	10" Stroke
1-7/8"	221	154	119
2"	201	140	108
2-1/4"	167	117	90
2-1/2"	141	99	76
3"	104	72	56

Depth to water that can be pumped by an average person and showing the 3 depths possible with 5", 7-1/2", and 10" pin positions on the pump handle. Above calculations are based on 50 lbs applied perpendicular to the pump handle and includes the hydraulic lift with 10% added for the leather friction and weight of the rod at the minimum mechanical advantage which occurs at midstroke.

$ 125.00 #WP2 PLASTIC HAND LIFT PUMP with 4 x 3 Slip ABS Base Flange Pictured to the right on top
Made of rugged reinforced engineered thermoplastics with stainless steel plunger rod. Will not rust or corrode. Will lift water a maximum of 25 feet. Molded cup will not wear or deteriate. Tapped for 2" pipe, which can be bushed down to smaller pipe.
$ 69.00 #HPP10 15" COUNTER TOP CISTERN PUMP Pictured to the right on bottom
Strictly for shallow well use, as it lifts by suction only. Pumps down to approximately 20'. Tapped for 1-1/4" pipe, has 3" cylinder size cup, and is heavy duty cast iron construction.

Typical Hand Pump System
( for a well 100' deep with a 50' static water level )

          $    722.00
          $      91.75
          $    125.16
          $    281.40
          $    143.00
          $      45.95
          $      13.95
          $ 1423.21

          $    165.00
        $    127.00
          $    101.64
          $    171.00

#11-HD Hand Pump
#66 MP 6" Sealed Flange
84' of 7/16" Galvanized Rod
84' of 1-1/4" Galvanized Pipe
2" All Brass Cylinder
5' of both rod and pipe for inside hand pump base
Cylinder Strainer
Total Cost of Basic System

Possible Add-on's
Pipe holder secures drop pipe while lowering or pulling galvanized pipe
Pipe Dog - Economical pipe lifting and setting tool
Each additional 21' of pipe and rod if your well is deeper
#12-HD with bibb spout in place of #11-HD

PACER Hand Operated
Barrel Pumps
for Agricultural Chemicals
or Petroleum Transfer

FREIGHT IS PREPAID IF ORDER IS OVER $ 1,000.00

Hand Pump Helpful Hints: click here for common questions about using a hand pump as a back-up water source.

HOME Y2K Hand Pump Simple Hand Pump Pump Jacks Cylinders

Prices effective July 20, 2008

Contact us

MADE IN THE U S A

BAKER / MONITOR FULL SIZE DEEP WELL HAND PUMPS

Typical Hand Pump System ( for a well 100' deep with a 50' static water level )

FREIGHT IS PREPAID IF ORDER IS OVER $ 1,000.00

Typical Hand Pump System
( for a well 100' deep with a 50' static water level )